Do a check of the saw chain lubrication each third battery charge.
- Start the product and let it run at 3/4 power. Hold the bar approximately 20 cm (8 inches) above a light coloured surface.
-
If the saw chain lubrication is correct, you will see a clear line of oil on the surface after 1 minute.
-
If the saw chain lubrication is not correct, do the following checks.
-
Do a check of the oil channel in the guide bar to make sure that it is not blocked. Clean if necessary.
-
Do a check of the groove in the edge of the guide bar to make sure that it is clean. Clean if necessary.
-
Make sure that the bar tip sprocket turns freely and that the lubricating hole in the guide bar tip sprocket is not blocked. Clean and lubricate if necessary.
-
Do a check of the oil channel in the guide bar to make sure that it is not blocked. Clean if necessary.
- If the saw chain lubrication does not work after following the steps above, speak to your servicing dealer.