To adjust the tension of the saw chain (
535i XP
)
Loosen the bar nut that holds the drive sprocket cover. Use the combination wrench.
Lift the front of the guide bar and turn the chain tensioning screw. Use the combination wrench.
Tighten the saw chain until it is tight against the guide bar.
Tighten the bar nut with the combination wrench and lift the front of the guide bar at the same time.
Make sure that you can pull the saw chain around freely by hand and that it does not hang from the guide bar.
Note:
Refer to
Product overview
for the position of the chain tensioning screw on your product.
Parent topic:
To adjust the tension of the saw chain