Tree operator

As a tree operator, follow the instructions below.

  1. Before you disconnect the safety strop from the ascent tools, you must attach the product to the harness. Attach the product to the harness through the belt eyelet or a steel ring on the safety strop.
    WARNING: Attach the safety strop to 1 of the recommended connection points on the harness.
    WARNING: If you use only the safety strop to attach the product to the harness, lower the product fully down with the safety strop. Do not let go of the product from a height.
  2. Use approved carabiners to attach the free end of the safety strop to one of the connection points on the harness. This is your primary connection point.
    CAUTION:
    The safety strop must only be attached to the rope eyelet.
  3. Make sure that you are in a stable and safe position to make the cut.
  4. Release the product from the secondary connection point, start the product and make the cut.
  5. Engage the chain brake directly after the cut is completed.
  6. Stop the product and put it in its secondary connection point.
Parent topic: To prepare the product for operation in the tree